Then go to the “Tool” temperature drop-down box and select “Off”. The extruder temperature in the graph should start to increase (within about 10 seconds or so). Navigate to the temperature graph and type in 50 followed by enter in the “Tool” temperature target feild.
If the temperatures are not accurate, review the sensor_type and sensor_pin settings for the extruder and/or bed. If it is increasing, remove power from the printer.
Verify that the temperature of the nozzle and bed are present and not increasing. Navigate to the Octoprint/Mainsail temperature graph. Start by verifying that temperatures are being properly reported. The numbers underneath X, Y, and Z control the movement distance. It’s also a good idea to issue a STATUS command after every RESTART to verify that the config file is successfully loaded.Īny time commands are requested to be issued, those will happen in the ‘Terminal’ or ‘Console’ tab of the OctoPrint, Mainsail, or Fluidd web UI, in the box for entering commands directly.Īny time movements need to be made, those will happen in the ‘Control’ tab / section of the Octoprint, Mainsail, or Fluidd web UI. Be sure to issue a RESTART command after every change to the config file to ensure that the change takes effect (type “restart” in the Octoprint or Mainsail terminal and then click “Send”). During this guide, it may be necessary to make changes to the Klipper config file. This section provides a list of steps to help confirm the pin settings in the Klipper printer.cfg file.
0 kommentar(er)
